Mercuriall AMPBOX 1.6.3 Mac download

AMPBOX runs as a VST, AU, or AAX64 plugin, plus a standalone app, so it can sit on a guitar track, a bus, or even the master channel when you want to re-amp.

Should it go on the track or the bus?

On a single track, it handles the whole chain — pedals, amp, and cabinet — so you get a finished tone without extra routing. On a bus, it lets you process multiple DI guitar tracks through the same amp setup for a consistent sound.

What about the cabinet emulator?

The built-in cabinet section lets you pick speaker and microphone types, so you can shape the tone to sit well in a mix without needing external impulse responses.

What typical jobs does it handle?

Use it for songwriting, demoing, or final tracking. It builds a complete guitar sound in one plugin, which makes it a practical choice for quick sessions and for IT setups where you want minimal plugin sprawl on the Mac.

First days with AMPBOX

After installing version 1.6.3, spend a session just loading presets and listening. The factory sounds give you a sense of what each amp model does without tweaking. Once you find a few you like, start adjusting the cabinet section — swap the speaker type, then the mic type, and move the mic position. Small changes here affect the tone more than the amp EQ in most cases.

Set up a simple template in your DAW with AMPBOX on a track and a clean DI signal recorded underneath. That way you can re-amp later by muting the processed track and sending the DI back through the plugin. It saves time when you want to A/B different amp settings without re-recording.

If you use the standalone app, plug your guitar in and test latency before you start serious work. The standalone mode is also useful for practicing or writing when you do not want to open a full DAW.

Scenario: A mix engineer cleaning up a live session

A mix engineer gets a Logic Pro session from a local band. The guitar tracks were recorded direct with no amp simulation. The engineer inserts AMPBOX on each DI track, picks a consistent amp and cabinet setup, and adjusts the mic position per track to match the song sections. The cabinet emulator lets the engineer match the room sound idea without loading separate IRs. All the tone shaping happens inside one plugin, so the session stays clean and the Mac does not choke on a pile of third-party plugins.

Appears in Logic Pro, Cubase, Studio One, and Pro Tools

AMPBOX shows up in Logic Pro, Cubase, Studio One, and Pro Tools 2019.12 or newer. It also appears in the AU folder for any DAW that supports Audio Units. Because it is a 64-bit plugin, it fits into modern plugin chains without wrapper issues.

On the workflow side, you can route the plugin output into macOS audio routing tools like BlackHole or Soundflower if you want to audition the tone in another app. The standalone app works with the Mac's built-in audio interface or any Core Audio device, which covers most USB and Thunderbolt interfaces.

For file management, keep the Mercuriall folder in your plugin scan directories. The activation is handled by the installer, so once it is authorized, you can move the plugin between sessions without re-entering anything.